Got it, continue to print. Paper Roll has run out – Paper is Jammed: A10 Thermal Receipt Printer Chapter 5. Voice Tool This program allows users to be notified of current printer status by voice alerts. Page of 53 Go. Remove all 5 screws from underside of printer as shown above.

Uploader: Moogubei
Date Added: 19 August 2016
File Size: 21.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64755
Price: Free* [*Free Regsitration Required]

Use only ground connected and quality certified power cords and cables. Avoid installing during thunderstorms.

Holding down the FEED button will discharge paper continuously until button is released. Inside Your Package Included in the package: Dip Switch Settings To print the manual completely, please, download it.

A 1cm receipt will be printed and voice function will be applied File is located at: Printer Cutter Replacement 1. A10 Thermal Receipt Printer Chapter 4. Don’t show me this message again.

Neither this manual, nor any of the material usn herein, may be reproduced without express written consent of the author.

A10 – Thermal Receipt Printer

Safety Information Printer Firmware NV Image Tool Image uploading tool. Please prepare new paper roll Cover is opened. Usb Interface Replacement The interface panel is now completely posbank a10 usb 3. Replace screws at either side of panel.

Press [OK] Step 5. Draw out the end of the paper roll and close the cover.

Posbank A10 User Manual

Install away from damp spaces or water-leaks. Beware of static occurrence during installation. Connect new serial interface to main unit.

Paper Roll has run out – Paper is Jammed: Connect new parallel interface to main unit. Remove the all 4 screws 2 posbank a10 usb and 2 black as indicated from upper side and 2 black screws from lower side.

Remove the 3 screws from the areas shown above poshank 8. Install NV Image Tool driver 3. Motherboard Replacement Cutter dissection 1. Locate the interface port posbznk the rear of the printer and connect the interface cable. Click [OK] Applied image will be printed out posbank a10 usb setting is completed. When power is on, green LED is lit.

Support l Pos hardware & Pos Software

Alternatively, you can always download the latest OPOS driver posbahk at: Make sure posbank a10 usb switch is in the OFF state before reassembling. Page of 53 Go. Select the [Interface] and [Port] Step 2. Got it, continue to print.